![]() Please apply the derating curve according to the operating temperature. When the product temperature exceeds 105☌, please use this product within the voltage and temperature derated conditions in the figure below. So even this kind of products, special derating have not set specially. The test voltage of these products is less than 150% of the rated voltage in the Durability / Operational Life Test. Less space by "2 coils in 1unit" structure inductor. Using non-magnetic core like alumina material, shows high performance in high frequency range. The use of magnetic iron powder ensure capability for large current. Wound structure inductor which has ferrite material core. Please contact us about the lead wire material. Since gold is used for the external electrodes, the capacitor can be mounted by die bonding/wire bonding.Ĭapacitor configured with lead electrodes and can be mounted by welding. Since silver palladium is used for the external electrodes,the capacitor can be mounted by conductive adhesive. This product has extremely low ESL and is suitable for suppression of noise, including high frequencies.Ĭontributes to noise suppression as an EMI filter Low-inductance product suitable for noise suppression. Polymer capacitor is no capacitance change with DC bias due to aluminum oxidized film for dielectric.īy making full use of the water repellence of the capacitor surfaces, this product minimizes Ion migration from the external electrodes (Terminations) that results from condensation. The metal terminals and leads relieve the stress from expansion and contraction of the solder, to suppress solder cracking.” “This capacitor is configured with metal terminals and leads connected to the chip. This capacitor is designed to prevent failures as much as possible by short mode caused by cracking when there is board deflection. This product suppresses acoustic noise, which occurs when a ceramic capacitor is used, by devising the materials and configuration. ![]() ![]() Product suitable for acoustic noise reduction and low distortion This capacitor is designed so that the parasitic inductance component (ESL) that the capacitor has on the high frequency side becomes lower. ![]() Products that are based on the electrical appliance and material safety law of Japan.īy devising ceramic materials and electrode materials, low dissipation is achieved in frequency bands of VHF, UHF and microwave or beyond. Products that acquired safety standard certification IEC60384-14. "Murata products containing SVHC and Information on safe use". Not impose any restrictions on the use of the products, nor is it a substance ban. REACH regulation impose restrictions of product applications and substance ban on the basis of Article 67.1.Ī Substance of Very High Concern (SVHC) in the Candidate List creates the duty to communicate information on substances in articles to allow safe use of the article, which is applicable to suppliers in Europe (Reach Article 33). Restriction of the substances contained in the article under Reach: (Directive 2006/66/EC, 2013/56/EU)īattery pack are excluded from RoHS directive (DIRECTIVE 2011/65/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 8 June 2011 on the restriction of the use of certain hazardous substances in electrical and electronic equipment). This product does not contain Mercury(Hg), Cadmium(Cd), nor Lead(Pb), and conforms to EC regulation values. Murata's Coin Manganese Dioxide Lithium Batteries are approved by UL. The annual self-discharge rate at room temperature and normal humidity is less than 1% of the nominal capacity. These materials are sealed by Murata's innovative technology to minimize battery self-discharge. The newly developed battery construction and electrolyte ensure maximum leakage resistance over a long span of time.Ĭarefully selected active materials are used for the active material as well as for the electrolyte. Such equipment is also maintenance-free (battery replacement is seldom required). Voltage characteristics remain stable even for a long period of discharge, greatly improving the reliability of equipment that uses the battery. This means that the number of batteries required for equipment can be halved for maximum space saving and weight reduction. The battery voltage is 3V, almost double that of normal alkaline or manganese batteries.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |